"House is on fire, Be back","One sec, Police are here again","BRB My fridge is running", Just scream, for like 10 seconds and unplug the cable, disconnect shortly thereafter
source: Reddit
As far as I know the problem is unfixable, because there isn't a way to tell the difference between real disconnects and unplug-the-network-cable-disconnects.
source: Reddit
Before I moved out of state I had my cable disconnect on my billing date to avoid extra charges, so I went about a week with no internet, Hero Clickers was not a great fill in at all :( horrible design and horrible rip-off.
source: Reddit
Some cars like the VW's are a simple one cable disconnect.
source: Reddit
It's best if you have a separate computer to use for the Internet and any downloads, then completely disconnect the computer with the issue from the network (remove network cable, disconnect from wifi.)
source: Redditshow context
Can you not just unplug the cable or disconnect from the wireless?
source: Redditshow context
You could hack the usb cable and disconnect those wires, or switch to a different hub.
source: Redditshow context
I always see my friends and coworkers yank on the cord part of the cable to disconnect the devices.
source: Redditshow context
I don't believe that people who quit unplug their Ethernet cable or disconnect from internet.
source: Redditshow context
Sit in the back near the exit, have a buddy stand in front of you to block the driver's view, unscrew the switch but leave it in place, wait till the bus stops and the doors open, then grab it, pull hard for the cables to disconnect and run.
source: Redditshow context
If you want to save money, perhaps cut off your power, cable, internet, disconnect your phone etc.
source: Redditshow context
You'll have to disconnect all the hard drives from their cables, and you'll probably need to remove the PCI/PCIe cards installed to get the room you need to pull that bracket out backwards.
source: Redditshow context
Leakage can be caused by loose or improper terminations within a customer's premises, and in those cases the cable company can demand to either investigate and fix the issue, or disconnect the customer's premises from the system.
source: Redditshow context
Actually if there is cable signal leakage coming from your premises, the cable company must either investigate and repair the leakage, or disconnect your service until it is fixed.
source: Redditshow context
Disconnect the potentially damaged cable and see if that solves the problem.
source: Redditshow context
I just wish it wasn't such a pain to connect/disconnect and the cable wasn't so annoying!
source: Redditshow context
What if, instead of reseating the powerline adapter, you simply disconnect the ethernet cable between the computer and the adapter and reconnect it.
source: Redditshow context
-In case of a power explosion DURING a raid, I always fill up a few batteries somewhat nearby my main defense turrets then disconnect them by a single cable.
source: Redditshow context
I think I'll just disconnect the cables and see if there's any resistance with them when moving them by hand.
source: Redditshow context
I don't have another sata cable so I have to disconnect my media HDD and reroute the cable out of the case to burn DVDs
source: Redditshow context
Disconnect your cable, and hold it in your hand, when you shift do you feel the cable pulling?
source: Redditshow context
He means disconnect your WiFi or unplug your ethernet cable.
source: Redditshow context
If you still have cable than the easiest way to trace out the cables is to disconnect the cables on the split side one at a time and see what TVs stop working.
source: Redditshow context
Duh disconnect from cable
source: Reddit
So either contact something to an input and switch tip that input and the tv will turn onto a black screen (will say "check signal cable" if you disconnect that device), what firmware do you have I know Samsung introduced a mini hub screen with a certain update (for 5 panel smart hub, yours model may only have the 2 panel but I don't remember)
source: Redditshow context
But cutting cables would drastically reduce the bandwidth and disconnects at least most private users, for some days or weeks.
source: Redditshow context
You could disconnect any continent by cutting all the cables.
source: Redditshow context
Yes, you can disconnect the cables you don't need.
source: Redditshow context
Alright, disconnect the cable completely and use your shifter... a brand new shifter, even without a cable would still make clicking noise when you shift... if it's not, then it's doa.
source: Reddit
You can just disconnect the power cables.
source: Redditshow context
You could always disconnect the trackpad manually by opening the computer and disconnecting the cable
source: Reddit
While I'm not one of these people, having wi-fi enabled in my shitty ISP provided router causes interference with the DSL thing and actually degrades the signal I am getting from the internet cable, causing dropouts/disconnects/crazy pings out of nowhere.
source: Redditshow context
Disconnect the battery cable (in your pic it has the five wires going into it) for a couple minutes.
source: Redditshow context
When I have had this problem for over 2 years upgraded my pc extensively had 3 different home hubs moved to a different house checked my virus program to see if that was the problem tried wired wireless tried a fat ps3 a slim ps3 used different ether net cables NONE of that solved the problem the only thing that solves the problem is to disconnect Netflix and the problem is COMPLETELY sorted so how is this not Netflix.
source: Redditshow context
You can disconnect the cable from the speaker itself.
source: Redditshow context
If possible, disconnect the power cables from the tower - take out the battery from the motherboard and put it back in to reset it.
source: Redditshow context
But then you have to be careful of crazy people taking jumper cables from you and how they randomly connect everything together and disconnect.
source: Redditshow context
I typically leave the adapter plugged in, and if I disconnect anything, I disconnect the cable from the adapter.
source: Redditshow context
So all you need to do is disconnect the cables from the power supply, and slide the new power supply in.
source: Redditshow context
The issue is usually not with he cable, but more with how the user disconnects the cable from the iPhone/iPad.
source: Redditshow context
I disconnect my devices HOLDING the plastic pin portion of the lightning cable.
source: Redditshow context
It already is more simplified if you have an Apple monitor (two cables now, power and Thunderbolt), which acts as a hub, but for those of us without it would make it a lot easier to disconnect.
source: Reddit
After that the next step would be to take the back off, remove the shield over the cables at the top, then disconnect and reseat those connections.
source: Redditshow context
As someone with cable (but it's downstairs, not in this room) this sounds like a good move, but then I remember that trying to watch online can result in buffering, delays, random disconnects, etc.
source: Redditshow context
The notion that they are at least acknowledging that a disconnect exists between the younger generation / cord cutters and cable television is a win it itself.
source: Redditshow context
Now how the hell are these cables run... lets see... is there a quick disconnect?
source: Redditshow context
If it does mess up in the future, you already know what to do: tell the software to disconnect from the printer (if applicable), then unplug and reconnect the USB cable to the PC or printer.
source: Redditshow context
You have to open the device, drill a hole in the housing, disconnect the internal antenna and run a cable to an external antenna; all things most people aren't willing to do to their iPhone.
source: Redditshow context
There seems to be a few disconnect cables.
source: Reddit
OP asked if you could completely disconnect Australia by cutting cables.
source: Redditshow context